Chord ElectronicsLtd is pleased to introduce the CPA3000 as the next in the range of our newgeneration of pre-amplifier products. Using similar technology as the highly successful CPA5000reference pre-amplifier the CPA3000 also features a high frequency switch modepower supply and ultra low noise circuitry to give the very best noise floorperformance.     Four pairs ofbalanced style XLR inputs allows for great flexibility with two additional RCAinputs for unbalanced sources. A single tape loop is available for playback andalso to record from any of the connected sources.     Front panel controlsallow for easy input and output selection if required but changes can also bemade via the supplied remote control. Two polished and nickel plated aluminiumcontrols feature prominently to manually adjust the volume and the balance andgive easy visual reference of the settings. Using the precision motorised Alpspotentiometers levels can also be adjusted by remote control. All settings areclearly visible via the large easy to read vacuum fluorescent display.     The CPA3000 isfeature rich with the inclusion of fully balanced AV Bypass circuitry thatallows for direct connection to an AV processor at full signal level, routingthe signal directly from input to output avoiding the volume potentiometer. This gives a truly flexible system for the purest two channel stereoreproduction converting for use in a multichannel AV system with a simple pressof a switch.     Cleverly situatedunder the main display, signal detection indicators have been replaced withhighly accurate VU meters. These give both clear signal detection and accurateinput level. Naturally via the front panel control, these may be selected ordisabled as required.     Remote triggeringoutputs are available at the rear of the unit to activate power amplifiers orAV processors. These are active as soon as power is applied via the rearswitch.     Packed with featuresand universal connectivity the CPA3000 also features our trademark aluminiumcasework construction. This gives it stunning looks and solid build quality tomatch. The CPA3000 is the ideal pre-amplifier for any system.         TechnicalSpecifications Unbalanced Inputs:Line 5, Line 6, Tape 1. 3 x pairs RCAPhono style, gold-plated with Teflon dielectric insulation. Balanced Inputs:Line 1 to Line 4. 3-pin female pairs offemale Neutrik XLR inputs. Outputs:1 x pair of 3-pin male Neutrik XLR output with 1 xpair of gold-plated RCA Phono wired asymmetrically in parallel. AV Bypass input:1 x pair female 3-pin Neutrik XLR input Intermodulation Distortion:-100dB all inputs Signal to Noise Ratio:: -93dB all inputs Frequency Range:2.5Hz 200kHz (-3dB) Nominal Gain:Fixed at x 1.1 THD:0.002% 20Hz  20KHz Channel Separation:10 Hz 90dB, 1kHz 90dB, 10kHz 90dB, 20kHz85dB Channel Balance:0.01dB Input impedance:Unbalanced 47k ohms, Balanced 94k ohms Output impedance:100 Ohms short circuit protected Output Offset:0mV both channels Max Input Voltage:10Vrms balanced, 5V rms unbalanced Max Output Voltage:15V rms balanced, 7.5V rms unbalanced Potentiometer Performance:0dB 0.5dB, -20dB 0.2dB, -60dB0.24dB ( 13 secs for full travel ) Operating Voltage:85 270V AC (50-60Hz) auto switching Dimensions:420mm (w) x 355mm (d) x 88mm (h) Weight:10Kg ]]>


Denumiri similare la Amplificator Chord Electronics CPA 3000: CPA3000

Galerie